Laars FT Circuit Board Revisions
Circuit
Board Part #'s and Revisions
June 3, 2020
KR
FLOOR
New # Model Old #
R2080600 MFTCF140 FT1616
(REV .04) SFN#
R2080603 MFTCF199 FT1898
(REV 1.01) SFN#
COMBI
WALL 140
New# Model Old#
R2080601 MFTCW140 FT1900 (Serial # F1500000-F1800308)
(REV.22) SFN#
R2080605 MFTCW140 FT1899 (Serial # F1800309-Present)
(REV.24) SFN#
COMBI
WALL 199
New # Model Old#
R2080604 MFTCW199 FT1899
(All Serial #'s)
(REV.24) SFN#
HEAT ONLY All SIZES
New# Model Old#
R2080602 MFTHW-All FT1052
(REV.10) SFN#
(Dip Switch Selection for BTU Size (80-199)
Related Articles
The 10 most common error codes on the Laars FT wall hung and FT floor mount boilers with explanations and most commonly seen causes and remedies
E10(Hard Lockout)-Flame has Extinguished 8 times: It is all about combustion. Air, Fuel, Spark. Burner plate. Error Code 10 E11(Hard Lockout)- Ignition Failed 10 times. Again, all about combustion. Air, Fuel, Spark. Ignitor, gas valve, blower, intake ...
FUSES for LAARS FT Circuit Boards
FUSES for LAARS FT Circuit Boards FT140, FT 199-Combi and Heat Only . Photo below. There are two replaceable glass type fuses mounted on the circuit board. The uppermost (top fuse) is a 10 AMP /125 Volt fuse and is for the 120V circuitry (internal ...
LAARS/Bradford White FT Models Circuit Boards with FT# and R# (current 11/2024)
LAARS/BRADFORD WHITE FT Circuit Board Part #'s with FT #'s and R#'s. ALL Models and Sizes. MFTCW140NA1XN Generation 1-Serial # F15000000-F18000308 COMBI WALL 140 CURRENT # MODEL # OLD # PREVIOUS # R2080601 MFTCW140 FT1900 FT1900 *SET DIP SWITCHES FOR ...
Laars MFTCW and MFTHW Circuit Board Part #'s with Revisions and Serial #'s
Circuit Board Part #'s and Revisions June 3, 2020 KR FLOOR New # Model Old # R2080600 MFTCF140 FT1616 (REV 1.01) SFN# R2080603 MFTCF199 FT1898 (REV 1.01) SFN# COMBI WALL 140 New# Model Old# R2080601 MFTCW140 FT1900 (Serial # F15xxx000-F18xxx308) ...
LAARS FT Wall and Floor Circuit Board DIP SWITCH settings. ALL MODELS.
LAARS FT Wall and Floor Circuit Board DIP SWITCH settings for all FT Models. See attached file.