tekmar Essay E0022 Balancing On/Off Injection Mixing Systems

• Related Articles

• Tech Tip: Stop Temperature Swings with the Right Mixing Valve

  Temperature swings in your water system? An oversized mixing valve might be to blame. The fix is simple: size the valve correctly for the system’s actual flow rates. The mistake often starts with sizing valves to match pipe diameters, assuming a ...

• tekmar Essay E006 Control of Radiant Floor Zones

• Zoning With tekmar RoomResponse

  How to improve comfort and efficiency using the RoomResponse™ signal During milder conditions and times when heat is added through indoor activity, appliance operation and solar gain, the RoomResponse™ signal requests a lower boiler temperature to ...

• Tekmar 356 (injection mix control) Quick Set Up Guide.

  Tekmar 356 Injection mix control quick set up : Room= 70 degrees Outdoor design= 10 degrees Terminal unit #1 Design indoor= 70 degrees Design Supply= 130 degrees Mix Temp= 145 degrees Sensor Location = Supply Minimum Boiler Temp= Off or Low (fine ...

• House Control 370 / 371 Upgrade

  This document (also attached) describes how to replace and upgrade existing House Control 370 or 371 systems. The main controller, zone controls and RTUs (Room temperature Units) must all be replaced with the new tekmarNet House Control & Thermostat ...