LAARS NeoTherm XTR Dual Element Domestic HW Tank Sensor
|
This bulletin clarifies how to wire a domestic hot water (DHW) sensor to NeoTherm XTR models. The domestic water temperature sensor used with NeoTherm XTR models is a dual element style. This is a single sensor with two elements, to provide additional accuracy and safety. Both elements need to be wired to the unit for proper operation. Wiring: |
|
|
|
|
When connected, the unit will automatically detect the presence of the sensor, and will perform the DHW thermostat function based on the settings selected via the DHW or DHW3 parameter screens. The temperature is displayed on the home screen, below the faucet icon. The controller initiates a call for heat, maintaining the set point within the on and off hysteresis values selected via the DHW or DHW3 demand screen, without any need for jumpers. |
Related Articles
Mascot MFTCW DOMESTIC WATER RECIRCULATION
ATTACHED depicts a typical MFTCW COMBI domestic recirculation piping diagram from Laars. *Please note that a sensor OR timer may be utilized for domestic hot water recirculation pump operation*LAARS FT 301/399 Cascading Instructions
LAARS FT 301/399 Cascading Instructions Cascade cables Cascade programming Click on attachment to viewLAARS FT 301/399 Overview
LAARS FT 301/399 Overview Dimensions Options Accessories Floor stand Click on attachment to view.tekmar 284 Suggested Sensor Locations For Primary-Secondary Systems
Atached below you'll find the tekmar 284 applications manual for more detail. Note: the Closely Spaced Tee's shown between S2 and S3 is often replaced by a hydraulic separator. Sensor Locations: STOP: PUT BE SURE TO PUT ALL SENSORS IN THERMOWELLS ...LAARS MFTHW DHW Priority with an Indirect Tank and Zone Panel
ATTACHED is a SAMPLE wiring diagram for wiring a DHW Indirect (notice the additional "RIB" relay as an add on, NOT supplied)with MFTHW boiler(s). This addresses the ability of using a DHW sensor in the indirect tank while maintaining DHW PRIORITY ...