RIB Relay-Up to 20 AMP output capable

• Related Articles

• Salus Smart Relay SC824ZB WIRING

  When wiring the Salus SC824ZB Smart Relay , pay special attention to wiring diagrams and schematics regarding "powered switching OR dry contact switching" . If wiring Salus Smart Relay thru a zone panel that is considered "power switching" . In ...

• Zoning With tekmar RoomResponse

  How to improve comfort and efficiency using the RoomResponse™ signal During milder conditions and times when heat is added through indoor activity, appliance operation and solar gain, the RoomResponse™ signal requests a lower boiler temperature to ...

• Laars FT Series Boiler Integration with Ecobee® Smart Thermostat

  Attached is the wiring diagram for Ecobee Smart Thermostat with Laars FTHW, FTCW, FTHF wall hung and floor boilers. *Please note that the FTHW and the FTHW DO NOT HAVE 24v output terminals wherein the FTHF DOES have 24v output terminals to power the ...

• PUMP CONTACT on LAARS FT 301/399 Models

  This bulletin clarifies wiring of a pump to the FT series 301/399 models. The FT series 301/399 boilers are equipped with pump contacts. These contacts are rated for 1.6 amps and a maximum voltage of 120V. If the pump that is wired to the FT boilers ...

• LAARS/Bradford White FT Wall Hung Combi and Heat Only(all sizes) AND Floor Boilers/Combi's-Common Venting

  Common Venting is NOT approved for the LAARS/Bradford White Residential FT Wall Hung Combi or Heat Only or Floor Combi or Heat Only Boilers ! This applies to ALL BTU SIZES(100, 140, 199) of the Residential FT. Adversely, the LAARS/Bradford White FT ...